I did this the other day with a Synthesis Forsberg blade. I normally use an Iginla so I had to make some changes to it. I used a heat gun to heat up the blade and then stuck it in a vice and then pushed the shaft in order to bend the blade. The fiberglass started becoming unattached from the wood in some spots but other than that it worked out pretty nicely.
I've done this before with a Fury Diamondback one-piece stick which so far hasn't had any problems, and with a Sher-Wood composite/wood hybrid type of blade which broke after about three or four uses. I think I cracked it when I was curving it, though.