Replacing a blade

[Islander102]

OK, so i have one of those one piece sticks, thats really a two piece (like the vast majority of them are). And i DESPISE my blade. So how do you get the origional blade out of the shaft, without flipping it upside down, cause that changes the whole flex areas of the stick. I know where the shaft hits the blade on this stick, so do i saw it there or somewhere else

Any advice is appreciated.

Click to read more...

 

[colton23]

it depends on if you are puttin a standard or taper blade if its a standard you should cut till the taper ends so it becomes a basic standard shaft if inserting a tapered you should cut till your blade will fit but you may have to chip out some of the old pieces of blade

 

[lotus]

Honestly I have heard of people just heating it up like a shaft and pulling, but i guess that depends on the stick.

 

[TBLfan]

SOME OPSs you can heat up and pull the blade out. As far as I know the only ones that are somewhat easy to do are TPS sticks.

 

[Islander102]

Mine is actually a TPS Adrenaline, so ill take all of your advice, thanks.

 

[TBLfan]

take your time and try not to overheat, it should come out relatively easy.

 

[lotus]

don't follow the avatar above mine ^.^

 

[TBLfan]

yeah, no blow torches!